getting error in bootloader - One (M7) Q&A, Help & Troubleshooting

after flashing elemntalx on insertcoin 4.4 based rom i got error
active cmdline overflow!

Related

[Q] GPE RUU Fail

I am trying to convert my HTC One to a GPE. I have unlocked the bootloader, S OFFed, changed my CID and MID and now I am trying to flash the non root RUU from here: http://http://forum.xda-developers.com/showthread.php?t=2358781
I get the first failed message (expected) then immediately run the same command.(fastboot flash zip nameofRUU.zip). It will load until it get to the line called:
Start image [pg2fs_spcustom] unzipping & flushing.....
It fails at this point and then run for a while giving some BYPASSED messages until it stops and says:
FAILED: (Remote: 51 partition update fail)
My phone can access bootloader but its only option is RUU. I am stuck on a black screen with the HTC logo in the center with triangles in each corner.
Any help you could give me would be great! Thanks!
You are running in ruu mode, correct? Maybe its a bad download, redowload the ruu and retry
AT&T HTC One
Baadnewz's InsertCoin 3.0-14
Flar2's Bulletproof 4.3

[Q] Remote: 12 siganture verify fail

Hi all,
Looking for some help - I had my htc one bootloader unlocked/ rooted and running venom rom.
I needed to go back to stock and lock the bootloader. So using the all in 1 tool, locked the bootloader which worked fine. Then went to install stock RUU and now I keep getting the same message in cmd screen when it tries to verify the signature. Any ideas??
You need to either find the correct ruu for your cid and mid, or s-off.
AT&T HTC One
Baadnewz's InsertCoin 3.0-14
Flar2's Bulletproof 4.3
aholloway21 said:
Hi all,
Looking for some help - I had my htc one bootloader unlocked/ rooted and running venom rom.
I needed to go back to stock and lock the bootloader. So using the all in 1 tool, locked the bootloader which worked fine. Then went to install stock RUU and now I keep getting the same message in cmd screen when it tries to verify the signature. Any ideas??
Click to expand...
Click to collapse
I think you need stock recovery also
dgtiii said:
I think you need stock recovery also
Click to expand...
Click to collapse
Ruu would reflash stock recovery anyway. It can be ran without it.
AT&T HTC One
Baadnewz's InsertCoin 3.0-14
Flar2's Bulletproof 4.3
Thanks for the replies.
I did S-off which has helps, not getting stuck on the sigantures now.
However I am getting stuck in the zip writing stage with the following error;
"FAILED (REMOTE:24 parsing android-info fail).
As far as I know I am flashing the correct RUU. It's from the andriodruu site is the OTA 02 UK variant which is what the phone came with.
I have tried a few other things. Installing stock recovery (didn't work, kept pulling up the red triangle so flashed cwm again). Tried using an RUU .exe file as well, but the version number didn't match after doing the "update" step.
No matter what I do the OTA zip file keeps getting the FAILED (REMOTE:24 parsing android-info fail)
Anyone have any ideas?? Have spent hours searching and trying different things but no joy!
aholloway21 said:
I have tried a few other things. Installing stock recovery (didn't work, kept pulling up the red triangle so flashed cwm again). Tried using an RUU .exe file as well, but the version number didn't match after doing the "update" step.
No matter what I do the OTA zip file keeps getting the FAILED (REMOTE:24 parsing android-info fail)
Anyone have any ideas?? Have spent hours searching and trying different things but no joy!
Click to expand...
Click to collapse
Change cid to 11111111
AT&T HTC One
Baadnewz's InsertCoin 3.0-14
Flar2's Bulletproof 4.3
---------- Post added at 08:52 AM ---------- Previous post was at 08:49 AM ----------
Also an ota is completely different than an ruu. You DO need the stock recovery and an unmodified system to flash ota. Change your cid like I said, run ruu.exe, then flash the ota.
AT&T HTC One
Baadnewz's InsertCoin 3.0-14
Flar2's Bulletproof 4.3
CoryTallman said:
Change cid to 11111111
AT&T HTC One
Baadnewz's InsertCoin 3.0-14
Flar2's Bulletproof 4.3
---------- Post added at 08:52 AM ---------- Previous post was at 08:49 AM ----------
Also an ota is completely different than an ruu. You DO need the stock recovery and an unmodified system to flash ota. Change your cid like I said, run ruu.exe, then flash the ota.
AT&T HTC One
Baadnewz's InsertCoin 3.0-14
Flar2's Bulletproof 4.3
Click to expand...
Click to collapse
Many thanks for your reply. Which RUU do I need to use?
I have the OTA for 02 UK which is the correct one, not sure on the RUU though....
Thanks in advance.
ok, so I ran the supercid, used the EU RUU which worked fine.
Now when I try and flash the 02 OTA it gets stuck on running bug_fix1 tool
Tried it a few times and stops in the same place... left it for about 10 mins each time before rebooting.
Any ideas on this one?

[Q] Flash Stock HTC M8 (AT&T) Rom through Unlocked Bootloader

Hey guys-
Need some guidance on how to fastboot flash the stock HTC M8 (AT&T) Rom. I tried flashing a custom ROM, InsertCoin M8 2.3.2, but it gave me a "remote : 24 parsing android-info fail" error.
1. Does anyone have a download link to the stock HTC M8 AT&T Rom?
2. Does anyone know why i'm getting the "remote : 24 parsing android-info fail" error?
Right now my Bootloader is unlocked. I do not have TWRP. I have no OS installed.
rr3mix said:
Hey guys-
Need some guidance on how to fastboot flash the stock HTC M8 (AT&T) Rom. I tried flashing a custom ROM, InsertCoin M8 2.3.2, but it gave me a "remote : 24 parsing android-info fail" error.
1. Does anyone have a download link to the stock HTC M8 AT&T Rom?
2. Does anyone know why i'm getting the "remote : 24 parsing android-info fail" error?
Right now my Bootloader is unlocked. I do not have TWRP. I have no OS installed.
Click to expand...
Click to collapse
This is the HTC One M7 forum so either you are posting in the wrong forum or you are trying to flash a rom for the M8 on your M7...

[Q] Help with S-off

Trying to get S-OFF (HBoot 1.57) but I'm running GPE 4.4.4_KTU84P.H1. I've tried installing different ROMs but phone gets stuck on boot screen. Firewater tells me I need an unsecure kernel (tried teaMSeven & ElementalX, same thing), Rumrunner gets to (10) pouring, then I get the "pray, run rumrunner again" message.
I think maybe I should have got s-off before moving to 4.4.4. Do I return to stock then try with a different rom (CM, perhaps), or is there something else I can try first?

[Q] HTC M8 root help

Hello everyone,
I rooted my HTC One M8 HK edition and now Im trying to get it back to stock. I've installed Sunshine to get S-off but keep getting a popup saying "Your device has a debuggable ramdisk (ro.debuggable=1). You need to flash a non-debuggable boot.img, stock would be best." The current ROM on the phone is InsertCoin and I tried getting HTC M8 RUU file on my phone but does't work. Are there any ROMs that are recommended to run sunshine? If not how can I install the RUU on my phone?
Flash one of the stock rooted ROM's from OMJ's RUU thread:
http://forum.xda-developers.com/showthread.php?t=2729173

Categories

Resources