So recently I did a stupid and accidentally switched off my OPO during an update installation and completely screwed it all up. I tried switching it back on only to find that it was stuck in a recovery mode loop. I then hit factory reset in a last ditch attempt to save the poor bugger without flashing it and even that didn't work.
I've then had to resort to flashing it using the OPO toolkit software on my PC however when connecting to the PC, my OPO only shows up as an MTP USB Device and nothing else. I have tried installing recommended Samsung drivers for the phone but I wasn't able to as it the "update drivers" button was greyed out on the MTP USB Device properties window.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Basically, the OPO toolkit will not work as no android devices are recognised by the PC even though an android device is showing up in the control panel.
There is no way I can currently access the settings on my phone due to recovery mode loop obviously.
The last thing I want to do here is end up with being forced to use the OnePlus support which I hope most of you understand why.
Thanks for any suggestions!
Hi,
This thread is being moved to your own dedicated forum , where the experts may be able to help you better.
Good luck!
Put it in downloading mode and then use adb to use the toolkit since bow u don't have a os on the OPO happened with me too but I fixed it this way
Sent from my A0001 using Tapatalk
Related
Hi everyone,
Seeking for idea(s) from a genius group.
I got a Nexus 6 with a broken screen ( really bad can't see anything , just black), want to get the data(photos) out of the phone.
the system debugging mode is not enabled, it's running on android 6.0.
here is what i have tried:
plug the phone into PC via USB, PC does not recognize any device, hold on power button and volume down for few seconds, the PC recognize the following: (fastboot shamu S)
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
can't post outside link
drive.google.com/file/d/0B3OMYlBbrdD2Ti1WSWpNdUEySjg/view?usp=sharing
/drive.google.com/file/d/0B3OMYlBbrdD2am92bUxWb0xuRkE/view?usp=sharing
not sure what can be done at this point.
also bought a used Nexus 6 in good working condition, swap screen did not work, the screen did not light up. ( some says the screen is locked to the motherboard, not sure about this).
googled some info, the last way would be remove the 32Gb NAND flash from the motherboard by un-soldering , and install to another motherboard, this may require some special tools and don't think it's a home DIY project.
Any shared idea(s) would be really appreciated.
Thanks.
James
hpmarsum said:
...., hold on power button and volume down for few seconds, the PC recognize the following: (fastboot shamu S)
Any shared idea(s) would be really appreciated.
Click to expand...
Click to collapse
http://stackoverflow.com/questions/...pull-all-files-of-a-folder-present-in-sd-card
The system debugging mode is not enable, will try to run the ADB. Thanks.
Hi all,
So, I was running fine with CROMi-X KitKat, but wanted to upgrade to Marshmallow (to install sw not supported in KitKat), so decided to try KatKiss 6.0. It's been years since I've played with flashing ROMs, but I did a little reading to refresh my memory. Then I rebooted into recovery (ClockworkMod), backed everything up, then wiped everything, formatted /data, and tried flashing the KatKiss zip file. At that point, it just sat there forever at the ASUS logo screen:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I've tried several times to boot back into recovery by holding the Vol+ and Power buttons, but it either doesn't boot, or boots to the above screen. I've connected it to my Mac w/ the Android SDK Platform Tools, but adb doesn't see any device listed. [I've got an old Windows laptop (XP?)] I could use if it will do something the Mac can't.]
Any advice on how I can save this tablet?
Have you found a solution finally?
Well, I haven't found a solution, but after letting it sit unplugged for months, I came across it today as I was straightening up. I plugged it in, waited maybe half an hour, and was able to boot it into recovery mode. I was then able to restore from a backup, and damned if it didn't reboot and come up just fine. No idea why it wouldn't boot into recovery before, but I'm happy camper!
I bought a used phone. The boot loader was unlocked from the beginning. I'm doing the steps to install Android 10, but something is weird.
I tried to go through the fastboot mode, but when I press the button, it doesn't respond, so I enter the computer through adb and there is no response, and then it returns to the system soon. When entering the boot loader mode to adb, a blue LED turns on. When I enter the recovery mode into adb, there is no reaction the same as when entering the fastboot. Also, when the power is turned off and plugged in, it automatically enters the flash mode.
When I first use the phone, the battery level is displayed when I plug it in, and it responds when I turn it on, but when I reinstall the stock rom of the same version with flashtool, nothing happens. There is no response even though I installed the 8.0 global version with the flashtool obtained from the deveploperworld homepage.
Strangely, the Android system works fine.
What should I do?
(I am Korean, and the sentences may be weird using Google Translate. Please understand.)
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I installed the Google USB driver and updated it, but it looks like this..
problem Solved!
Inscartia said:
I installed the Google USB driver and updated it, but it looks like this..
Click to expand...
Click to collapse
Solved the problem! If the Google USB driver does not work when recognized as other devices, try updating with the Samsung USB driver. It is recognized as a samsung adb interface and is recognized as normal in the fastboot devices command. You can install twrp in this state!
Hi guys,
My pixel 5 died recently while playing a video. It will not turn on, nor make any sound. There is no haptic feedback as well when I start the device. The only time it is detected is when I boot it up in fastboot mode (Press and hold Power and Vol Down). It is detected as Pixel 5 on windows pc. It is detected under fastboot devices but I can't seem to do anything else with it. I am unable to get an adb connection. I don't remember if usb debugging was turned on or not on my device before it died, it most likely was enabled but can't get it connected via adb.
Note: The phone is bootloader locked
My question is can I recover my data from the phone through fastboot only without a working display?
Thanks.
Perhaps you could try booting into twrp and see if you can access the data that way?
Thanks. I did try that but I can't really boot into recovery as the device is bootloader locked.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
nabeeltariq said:
Thanks. I did try that but I can't really boot into recovery as the device is bootloader locked.
Click to expand...
Click to collapse
Oh no. I hope someone can prove me wrong but I believe your only option now is to send it in for a repair.
swangjang said:
Oh no. I hope someone can prove me wrong but I believe your only option now is to send it in for a repair.
Click to expand...
Click to collapse
This. Without bootloader unlock, your chances of dumping partitions are zero.
@nabeeltariq Are you able to access stock recovery? You may be able to sideload an OTA package to get working again.
Hello! This is my first time creating a post for a problem I had because I'm really desperate.
Some days ago, my Note 8 showed the wet port notification and gave some problems when charging. Then, the notification dissapeared but the problems remained. For some days, I've not been able to charge the mobile when it had battery. I had to wait until it was completelly empty, not just to turn off, but to not be able to turn on again. That's the only time when it charged. I've tried to reinstall the original ROM (I don't remember wich one I have but I installed some things and rooted the phone when I got it, half a year ago.), but I can't use ODIN as when I connect it to my PC it says that the device was not recognised and is not detected at all.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I've now wiped the phone and I think that now is able to charge when off, but I'm not sure as it seems to charge whenever it wants.
Thanks for the help to anyone who responds.
[Update]
I've wiped dalvik cache and it seems to charge while on. But my PC still doesn't recognise it.
[Update]
Fast charging does not work, just as before (when it charged was on slow mode).
[Update]
As root was not installed I thought that maybe I had the stock fimware and disabled OEM Unlock. Now it gives me the "Custom binary blocked by FRP Lock." error both on system and twrp so I'm bricked. Also, Odin still doesn't recognise the phone. I don't know what to do now...