Hi:
I've been searching for info how to achieve the following, which I can't get done so far:
I have stereo bluetooth headphones with a mic. These are great for receiving calls, when you don't have the phone easily accessible, like in the car etc.
They have only two buttons, one is a two-way joystick for loudness. The other one is a receive/hangup button using which you can accept incoming calls.
What I'd like to do is to enable it to activate voice dial when I press it, to make a phone call.
So far I've only discovered that if I hold it depressed a long time, then the headset redials the last-dialed number.
In some instances after a call, when I've pressed the button, voice dial has come up and asked for the called id, however I cannot replicate this behavior, and it doesn't do it when the home screen is visible. Only I think after I've dialed from the headset, then hang up. Then at that screen press the button, but it's not stable.
So it seems though, to use the button to activate voice-dial is possible. I'd just like to set it up so that it works.
Anyone know how to?
Try holding one of the buttons
Depending on the BT adapter, you might have to hold down the receive/hangup button till you hear a confirming beep.
its usually a short press for voicedial a little longer press for redial last number. so try just doing short press insead of holding it down
I found that my Galaxy S cannot sustain in Silent or Vibrate Mode whatever I set. I set the phone to Silent mode during my working time but the phone will enable back the sound after I make a call or answering a call.
I tried to use "Setting Profile" software also same.
Is that anywhere to set the phone to permenent Silent Mode until I manual turn on the sound?
I have a BlueAnt Endure headset connected to my XPZ. Randomly my phone will dial someone from my phone book. I have just realised that it is because I keep the headset in my pocket (when not in use) and if I accidentally lean on it and subsequently press the command button twice within a few seconds it will enable the 'Voice Dialer'. It will then interpret any noise or voice into random numbers or sometimes a phonebook name.
I have called BlueAnt and they tell me that I cannot disable the 'Voice Dialer' command within the unit.
Is there a way to disable this action on the phone? Is this a SONY or an Android thing?
Do I need to install a custom ROM to disable this function?
ty
I have a WiFi Near profile which activates if the CELLA variable is equal 1 and my home wifi is near.
It turns on the wifi which is working fine and there is a command Silent mode OFF which is not working for some unknown reason. I have also tried to replace this command with the Ringer volume set to 5 command but this also doesn't work.
I can feel one vibration if this profile becomes active so I think this maybe working but after that it is immediately turns in to vibrate mode.
What could be the problem?
My speaker phone has changed to a Bluetooth symbol and when I press it it gives me the option of speakerphone or phone? Why has this suddenly changed? Or have I pressed something by mistake?